Salted Caramel Chocolate Fudge Recipe - The Cookie Rookie® (2024)

FAQs

How do you beat fudge? ›

Beat the mixture

After letting the fudge cool, it's time to beat it. It is important to stir constantly with a wooden spoon until the mixture starts to thicken and its surface starts to look dull or matte. Now is the time to stop beating and pour the fudge into a mould.

Beating the cooled batter is one of the crucial steps of fudge-making, but overbeating can turn fudge hard as a rock. Pay close attention to the change in appearance and only beat the fudge until it loses its glossy sheen.

The main reason is that your Fudge has not reached the optimum temperature. If your mixture only reaches 110 or 112 degrees Celsius it will always be soft. That's why we recommend investing in a sugar thermometer. Another reason your Fudge is not setting is that the ratio of liquid to sugar is too high.

Incorrect beating may make the fudge chewy.

It could be because you began beating the mixture too fast (while it was still hot), resulting in hard, unappealing crystals and a chewy texture. Be sure to allow the mixture to cool completely before beating it to a sufficient length!

However, if you don't beat it at all, the crystals won't form properly, so your fudge won't set. If you forget to beat the fudge, try heating it back up over low heat, then beat it once it's slightly softened. If you beat the fudge too soon, the crystals will be too large, and the fudge will be grainy.

Beat Thoroughly. While you shouldn't mix the fudge mixture when it's hot, you should beat the mixture once it has been removed from the heat and cooled. Once again, turn to your candy thermometer.

If you beat it by hand with a wooden spoon, crystallization can take between 5 to 15 minutes. The process is much faster with an electric mixer, just 2 to 3 minutes. The mixture is ready to be poured into a pan when it has visibly thickened and lost a bit of its luster.

While beating by hand is the traditional method, you can use an electric mixer if you have one. Fit the mixer with the paddle attachment and turn it on medium. Beat it just until it starts to thicken and lose its gloss. It is easy to overbeat fudge with a mixer, so watch it carefully and check it after every minute.

Simply heat on the stove with milk while stirring frequently. Use approximately 1/3 cup of milk for 1 lb of fudge. Cut fudge into small chunks for easier melting. Many flavors make excellent sauce, especially Belgian Chocolate, Pure Maple, Chocolate Raspberry and Chocolate Mint.

OPTION 2) Freeze it overnight. Cut it into squares. Cover each square thickly in melted chocolate, ensuring no part of the fudge is exposed. Cross your fingers and hope that the chocolate sets firmly before the fudge starts to thaw, and later impress your friends as you present them with your soft-centred chocolates.

Why does fudge fail? ›

Homemade Fudge Doesn't Always Set

If your fudge doesn't firm up after a few hours, you either have too high an amount of liquid to sugar, or your mixture hasn't reached the soft-ball stage. Using a candy thermometer can help home cooks avoid this problem.

Put it in a microwave safe bowl that is large enough that it won't boil over. Reheat it to the boiling point and cook for about 3 more minutes. Then you can beat some powdered sugar into it if this doesn't make it set. I do not make fudge.

Good use of failed fudge: fudge that is too hard, too soft, too runny, too sugary, too chewy, etc. Proportions are as follows: for every 2 cups (roughly 1 pound yield) of any failed fudge that is not runny, you'll need 1 egg, ½ cup all-purpose flour, and ½ cup milk. If fudge is soupy, halve the milk (to ¼ cup).

Once a seed crystal forms, it grows bigger and bigger as the fudge cools. A lot of big crystals in fudge makes it grainy. By letting the fudge cool without stirring, you avoid creating seed crystals.

As toffee is hard crack, it has a more brittle texture. Fudge, on the other hand, is softball – making it soft and crumbly. The difference between caramel and toffee is greater, as caramel has a more liquid consistency and is usually pure sugar (it doesn't contain butter or flour).

Immediately stir the fudge with the wooden spoon or beat on low speed with an electric mixer. The mixture should seem runny at first. Continue to stir vigorously or beat on low speed until the mixture begins to thicken slightly and loses some of its shine, 18 to 22 minutes.

Beat the mixture until it just loses it's shine and becomes very thick (this should take about 5-10 minutes). The longer you beat once it starts to thicken then the more crumbly the final fudge will be. If you like it smooth - beat it only until comes away from the sides of the pan and sticks well to the spoon.

Once a seed crystal forms, it grows bigger and bigger as the fudge cools. A lot of big crystals in fudge makes it grainy. By letting the fudge cool without stirring, you avoid creating seed crystals.